The growth of transverse cracks under expanding spherical contact in a model system consisted of soda-lime glass bonded to a polycarbonate substrate is observed in situ from below or from the polished edge of the bilayer. Abrasion or chemical etching is employed on the coating surfaces to control the initial fracture. In the limit case of monoliths, the crack mouth becomes fully engulfed by the...

Background: A thoracic curve degree of greater than 45° leads to thoracic hyperkyphosis, and its common treatment method is orthotic treatment. The acceptance rate of spinal orthosis depends on in-brace correction, patient`s compliance and quality of life. Objective: In this study, we aimed to compare in-brace correction, compliance and quality of life in patients with thoracic hyperkyphosis ...

It is necessary to manage the fatigue crack growth (FCG) once those cracks are detected during in-service inspections. In this paper, a simulation program (FCG-System) is developed utilizing the commercial software ABAQUS with its object-oriented programming interface to simulate the fatigue crack path and to compute the corresponding fatigue life. In order to apply FCG-System in large-scale ma...

abstract introduction: this study was aimed at assessing the effect of a new thoracolumbar orthosis on patients with scheuermann's kyphosis referred to iran medical university of tehran in collaboration with a clinic of technical ortopedea in isfahan. material and method: this new version of orthosis had a dynamic system as compared to previous ones which enabled the spine to extend. a question...

in this paper a new guidance technique for ballistic missiles and launch vehicles is proposed. generally the lambert guidance is used to generate missile nominal (correlated) parameters through powered flight to put it in a ballistic flight path. because of uncertainties and undesired factors, the nominal position and velocity obtained by lambert technique need to be followed in actual flight. ...

In this paper, the plates made of functionally graded material (FGM) with and without a crack are numerically simulated, employing the finite element method (FEM). The material property variations are defined to be fully continuous; therefore, the elements can be as small as required. For this purpose, variations of the material properties are applied in both the integration points and in the n...

In the present research, the mixed-mode fracture mechanics analysis in a plate with central hole under tensile loading is considered. It is assumed that a plate containing two symmetrical hole-edge cracks is bonded with two dissimilar planes. The stress intensity factors at the crack tips are calculated. The problem is modeled in Casca software and this model is analyzed with Franc software. Th...