The aim of the present study was to investigate the effect of quenching and tempering temperatures on the microstructure, mechanical properties and the wear characteristics of medium carbon-high chromium wear resistant steel. In addition, the dominant wear mechanisms were studied. For this purpose, austenitizing and tempering temperatures were selected in the ranges of 900- 1000 °C and 300- 500...

Wear is a critical factor in determining the durability of microelectromechanical systems (MEMS). While the reliability of polysilicon MEMS has received extensive attention, the mechanisms responsible for this failure mode at the microscale have yet to be conclusively determined. We have used on-chip polycrystalline silicon side-wall friction MEMS specimens to study active mechanisms during sli...

In tribological applications, because of the corrosive problems of the metals in water applications, poly-ether-ether-ketone (PEEK) and its composites are preferred for rubbing materials. As it is known PEEK is a high performance semi-crystalline thermoplastic polymer and has received significant attention in recent years. This is due to its high mechanical strength and elastic modulus, high to...

In this research, B4C-Ni cermet coating was sprayed on the surface of 4130 steel from B4C and Ni feed-stockpowders using high velocity oxy-fuel (HVOF) method. In order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 N.Phase analysis of the coating after spraying was studied ...

In this Study, surface of medium carbon steel (AISI 1045) was modified by titanizing followed by plasma nitriding. Titanizing was performed using pack cementation method, in a pack mixture of ferrotitanium, ammonium chloride and alumina, at 1223 K for 45 and 180 min.  Plasma-nitriding was conducted at two temperatures of 803 and 823 K for 5 h, in a gas mixture of 75%N2+25%H2. The samples were c...

In the present investigation the effect of the substrate dilution on room and high temperature (550 and 700 oC) tribological behaviour of nickel based hardfaced coating deposited by plasma transferred arc onto a grey cast iron was investigated and compared to the uncoated grey cast iron. At room temperature, the wear loss of coatings was independent of the substrate dilution and similar to the ...