The effects of dissolved air in the dielectric liquid FC-77 on flow boiling in a microchan-nel heat sink containing ten parallel channels, each 500 ␮m wide and 2.5 mm deep, were experimentally investigated. Experiments were conducted before and after degas-sing, at three flow rates in the range of 30– 50 ml/ min. The dissolved air resulted in a significant reduction in wall temperature at which...

Thermal management has become a critical issue for high heat flux electronics and energy systems. Integrated two-phase microchannel liquid-cooling technology has been envisioned as a promising solution, but with great challenges in flow instability. In this work, silicon nanowires were synthesized in situ in parallel silicon microchannel arrays for the first time to suppress the flow instabilit...

Measurements of space and time resolved subcooled pool boiling of FC-72 in low, earth, and high gravity environments were made using a microscale heater array. Data from each heater in the array were synchronized with highspeed digital video. The boiling behavior was dominated by the formation of a large primary bubble on the surface which acted as a ‘‘sink’’ for many smaller bubbles surroundin...

Some thermodynamic quantities for the Stockmayer potential (12, 6, 3) with a hard core are analytically evaluated at an isobaric process. The parameters of polar gases for 16 substances are obtained. Also some thermodynamic quantities for H2O are calculated numerically and drawn graphically. The inflexion point of the length L corresponds physically to a boiling point. L indicates the liquid ph...

In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...

Cooling technology becomes more important because of the increase in heat generation density of semiconductor chips. Boiling and two-phase flow is expected as one of the most effective methods to cool the electronic devices because of its superior heat transfer characteristics. Because the boiling heat transfer depends on the selection of coolant, the development of liquid mixtures and their co...

The literature pertinent to various aspects of drop evaporation on a heated surface is reviewed. Both the laser shadowgraphic and direct photographic methods are employed to study thermal stability and flow structures in evaporating drops in all heating regimes. It is revealed that four flow regions exist in stable and unstable type drops at low liquid-film type vaporization regime. As the surf...

in this work an analytical equation of state has been employed to calculate the pvt properties ofternary refrigerant mixtures. the theoretical eos is that of ihm, song and mason, which is based onstatistical-mechanical perturbation theory, and the two constants are enthalpy of vaporization δhvapand molar density ρnb, both at the normal boiling temperature. the following three temperaturedepende...