INTRODUCTION There is concern regarding the fretting wear of rolling bearings used in various types of machines, especially those that oscillate minutely. Because fretting wear results in the deterioration of the acoustic properties of bearings, rise in the bearing torque, and flaking originating from wear scar, fretting wear has a negative impact on the performance of rolling bearings. Maruyam...

INTRODUCTION: Several different types of devices are available to aid in spinal fixation. Clinical results are usually acceptable but aseptic loosening may occur, and may be accompanied by particles of wear debris. Debris is now recognized as a probable cause of loosening of total joint prostheses, but the magnitude of debris associated with spinal devices, and it's relation to motion are uncle...

Corrosion of modular taper junctions of hip implants may be associated with clinical failure. Taper design parameters, as well as the intraoperatively applied assembly forces, have been proposed to affect corrosion. Fretting corrosion is related to relative interface shear motion and fluid ingress, which may vary with contact force and area. It was hypothesised in this study that assembly force...

Abstract: This paper studies the dynamic response of a wind turbine gearbox under different excitation conditions. The proposed 4 degree-of-freedom (DOF) dynamic model takes into account the key factors such as the time-varying mesh stiffness, bearing stiffness, damping, static transmission error and gear backlash. Both the external excitation due to wind and the internal excitation due to the ...

A new advanced system for Ultrasonic Peening (UP) of materials, details and welded elements was developed recently. The UP produces a number of beneficial effects in metals and alloys. Foremost among these is increasing the resistance of materials to surface-related failures, such as fatigue, fretting fatigue and stress corrosion cracking. The beneficial effect is achieved mainly by relieving o...

Modular femoral components have been developed to aid in recreating native femoral version, limb length, and offset in total hip arthroplasty. Use of modular implants results in cost savings, as well. Inventory can be reduced while allowing intraoperative flexibility and options. With modular implants, the femoral prosthesis can be built in situ, which is helpful in minimizing incision length a...

Considered as a plague for numerous industrial assemblies, fretting, associated to slight oscillatory displacement, is encountered in all quasi-static contacts subjected to vibration. Depending on sliding conditions, cracking or wear damage can be observed. During the past three decades there has been a huge development in surface treatments. Thousands of new surface treatments and coatings are...

This paper describes statistical determination of fretting-induced failure of an electro-deposited coating. A fretting test is conducted using a ball-on-flat plate configuration. During a test, a frictional force is measured, along with the relative displacement between an AISI52100 ball and a coated flat specimen. Measured data are analyzed with statistical process control tools; a frictional ...

A systematic investigation of the fretting fatigue behavior of the titanium alloy Ti-6Al-4V in both the mill-annealed (MA) and the solution-treated and overaged (STOA) conditions was carried out. A sphere-on-flat fretting fatigue device was used that facilitated real-time control and monitoring of all the relevant parameters such as the contact geometry, contact (normal and tangential) loads, a...

Fretting fatigue behaviour of Ni-free high-nitrogen steel (HNS) with a yield strength of about 800 MPa, which was prepared by nitrogen gas pressurized electroslag remelting, was studied in air and in phosphate-buffered saline (PBS(-)). For comparison, fretting fatigue behaviour of cold-rolled SUS316L steel (SUS316L(CR)) with similar yield strength was examined. The plain fatigue limit of HNS wa...