In recent years, there has been an increasing demand for high-speed digital circuits at low power consumption. This paper presents a design of input stage of Operational Amplifier i.e cascode differential amplifier using a standard 65nm CMOS Technology.A comparison betweem gate-driven, bulk-driven and cascode bulk driven bulk-driven differential amplifier is described. The Results demonstrate t...

A body-biasing compensation scheme based on two proportional-toabsolute-temperature (PTAT) circuits is proposed to reduce the PVT variability of the DC gain of cascode amplifiers. A brief description of a basic PTAT is given as well as its application to cascode-based operational transconductance amplifiers. Simulation results show that the proposed compensated circuit amplifier exhibit a (DC) ...

The design of high-accuracy analogue circuits is becoming a difficult task with the scaling down of supply voltages and transistor channel lengths of the current mixed-signal integrated circuits. Most of this kind of circuits require the use of the highestperformance active cell: the operational amplifier (op amp). Designers are continuously working toward tradeoff solutions between gain, input...

A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...

This work presents a 2.4 GHz low noise amplifier (LNA) for wireless sensor network in CMOS 0.13-μm Silterra process. The forward body bias technique with cascode configuration has been adopted in order to implement a suitable LNA for low power consumption target. The supply voltage was varied from 0.4 V to 0.6 V as to optimize the tradeoffs for LNA performances. The simulation results show that...

144606-7171-IJET-IJENS © December 2014 IJENS I J E N S Abstract— This paper shows the design of a broadband low noise amplifier (LNA) for ultra-wideband (UWB) applications. The proposed LNA uses cascode configuration technique followed by an inductive inter-stage network to realize the flat gain throughout the UWB band. The inductive inter-stage network is cascaded to a common source amplifier ...

A 1.2-V fully integrated 0.35m inductively degenerated common source CMOS low-noise amplifier has been demonstrated at 2.4 GHz in this paper. A simple common source configuration can be operated at lower voltage and has lower output impedance when compared with a conventional high output impedance cascode LNA circuit topology. The input matching inductance, output matching inductance, and sourc...