Transient thermography employs preheated surface temperature variations caused by delaminations, cracks, voids, corroded regions, etc. Often, it is enough to detect these changes to declare a defect in a workpiece. It is also desirable to obtain additional information about the defect from the thermal response. The planar size, depth, and thermal resistance of the detected defects are the param...

The use of titanium and its alloys has increased in various industries recently, because of their superior properties of these alloys. Titanium alloys are generally classified as difficult to machine materials because of their thermo-mechanical properties such as high strength-to-weight ratio and low thermal conductivity. Laser Assisted Machining (LAM) improves the machinability of high strengt...

Many manufacturing defects could be seen in cylindrical turning. Some of these defects are: elastic deformation of work-piece, nonlinear backlash of cutting set – machine – workpiece, unknown geometry of untreated part, thermal deformations, vibration of set and machine. Deflection of workpiece under cutting forces will cause different levels of processing of workpiece 1 . Nonlinear backlash of...

Induction heating process was investigated numerically and experimentally. Cylindrically shaped steel workpiece was heated with different heating protocols. Numerical model with coupled electromagnetic and thermal physical phenomena was solved using the finite element method. Temperature-dependent and temperature-independent steel material properties were considered and their impact on simulati...

The present research work is concerned with the effects of optimum process variables in elevated temperature hydro-mechanical deep drawing of 5052 aluminum alloy. Punch-workpiece and die-workpiece friction coefficients together with the initial gap between the blank holder and matrix were considered as the process variables which, in optimization terminology, are called design parameters. Since...

ultrasonic assisted drilling (usd) is new technique to drill difficult to machine materials. in this method, tool or workpiece vibrates with amplitude of few microns in addition to conventional drill bite rotation. in this experimental research, the bone was drilled both conventionally and using uad, then the thrust was measured in two methods at feed rates of 50, 75 and 125 mm/s and 500, 710 a...

The paper presents an investigation on the effect of process variables and material condition on forgeability of magnesium wrought alloys of Mg-Al-Zn group, AZ31, AZ61 and AZ91. The experimental work includes studies of forging capabilities of the alloys in closed-die forging at hot and warm-working temperatures. Forging tests are performed for material both in as-cast and asworked condition, f...

In the current work we present approach to study the mechanism of the cutting of abrasive grains in the grinding wheel using finite element analysis (FEA). The simulation process is done by separating two abrasive grains from the grinding wheels and the microprocess of material removal in the case of surface grinding is simulated. Modelling was done on the workpiece steel S-7 and material grain...