This paper presents a novel numerical technique to simulate the crack propagation process for inhomogeneous solids. The criteria of crack growth and path selection are expressed in terms of some simple functions of fracture energy and loading phase angle. The energy release rate and loading phase angle for mixed mode cracks are evaluated by the ®nite element method with a mesh-adaptive techniqu...

Shot peening beneficial effects on fatigue life of mechanical components are well known. However, there are some reports in the literature that indicate inappropriate shot peening parameters tend to reduce the fatigue life. It is therefore, the purpose of this study to find a logical quantitative justification for these observations. Using finite element method, a dynamic elastic-plastic simula...

An elastic finite element analysis was conducted to evaluate the stress distribution in the initiation zone of the adhesive rupture during the 3-point bending test. This test is used to measure the adherence between a polyepoxy adhesive and aluminum alloy with different surface treatments. The purpose is to compare, in the high stress concentration areas, the stress fields calculated using fini...

Continuum approaches to fracture regard crack initiation and growth as the ultimate consequences of a gradual, local loss of material integrity. The material models which are traditionally used to describe the degradation process, however, may predict premature crack initiation and instantaneous, perfectly brittle crack growth. This nonphysical response is caused by localisation instabilities d...

Presented is a concise summary of recent Northwestern University studies of six new problems. First, the decrease of fracture energy during crack propagation through a boundary layer, documented by Hu and Wittmann, is shown to be captured by a cohesive crack model in which the softening tail slope depends on the distance from boundary (which causes an apparent size effect on fracture energy and...

ÐFatigue crack initiation and multiplication of the unnotched SCS-6 silicon carbide ®ber-reinforced titanium matrix composites with di€erent matrix and interfacial properties have been investigated experimentally and analytically. Ti±15V±3Al, Ti±6Al±4V, and Ti±22Al±23Nb were chosen as matrix materials. The initiation and propagation of each individual matrix crack as a function of fatigue cycle...

The natural initiation and growth of short cracks in Inconel 718 U-notch specimens has been studied at 600C in air. U notches were introduced through broaching, and hardness traces and optical microscopy on cross sections through the U notch broaching showed that the broaching process had introduced a deformed, work hardened layer. Fatigue tests were conducted under load control using a 1-1-1-1...

It is considered that the process of fatigue fracture could be arranged the three classes, i.e., crack initiation, crack propagation and fracture. Of these the second process is important from the following point of view. (1) As has so far been reported in many publications, the importance of crack propagation process in total fatigue life increases in proportion to the increase in the stress c...

Abstract—A model to predict the plastic zone size for material under plane stress condition has been developed and verified experimentally. The developed model is a function of crack size, crack angle and material property (dislocation density). Simulation and validation results show that the model developed show good agreement with experimental results. Samples of low carbon steel (0.035%C) wi...

In this work, the uniaxial and biaxial fatigue behaviour of maraging steel (18Ni300) obtained by additive manufacturing was studied. The material evaluated using several load paths different levels. predictive capacity life crack initiation angle critical plane methods Liu (I II), Chu, Conle, Bonnen (CCB) were evaluated. results showed that normal stresses had a strong effect on life. general, ...