Erbium/ytterbium-dopped Y0.9Er0.1−xYbxVO4 samples with x = 0, 0.01, 0.05 and 0.09 were synthesized by hydrothermal synthesis at basic pH urea addition. For comparison purposes, another sample 0 was also prepared the solgel method. X-ray diffraction patterns indexed on basis to a tetragonal symmetry of space group I41/amd Z 4 compatible zircon-type, in good agreement FTIR spectra. Additionally, ...

The Er-doped LiNi0.5Mn1.5O₄ (LiNi0.495Mn1.495Er0.01O₄) sample was successfully prepared by citric acid-assisted sol-gel method with erbium oxide as an erbium source for the first time. Compared with the undoped sample, the Er-doped LiNi0.5Mn1.5O₄ sample maintained the basic spinel structure, suggesting that the substitution of Er3+ ions for partial nickel and manganese ions did not change the i...

As light pulses propagate along the optical fiber, their energy dissipates. Beyond a certain distance the number of photons in pulses becomes too small to be detected. The optical pulses in fibers are energized by utilizing optical fiber amplifiers. The rapid growth of the internet and data traffic in optical fiber communication networks has stimulated the study of wideband optical amplifiers. ...

This paper is describing and investigating four crucial areas of Erbium Doped Fiber Amplifier (EDFA). First is the atomic part, where it is meaningful to give deep and details information of erbium spectra structure and its energy level. The atomic spectrum is one crucial part in defining and understanding amplification phenomena. The second part based on understanding, investigating and analyz...

A cost effective method of generating multi-wavelength based on the cascaded four wave mixing effect is experimentally demonstrated. The proposed scheme is free from external tunable laser sources and pump modulators, resulting from the use of a broadened linewidth tunable dual wavelength erbium-doped fiber laser as intracavity pump. In this configuration, the number of four wave mixing cascade...

Abstract: Erbium-doped fiber laser systems exhibit a large variety of complex dynamical behaviors, bifurcations and attractors. In this paper, the chaotic behavior which can be achieved under certain conditions in a laser system with erbium-doped fiber, is discussed. The chaos in this system occurs through several standard scenarios. In this paper, the simulation sequence of quasiperiodic, inte...

On-chip, high-power, erbium-doped distributed feedback lasers are demonstrated in a CMOS-compatible fabrication flow. The laser cavities consist of silicon nitride waveguide and grating features, defined by wafer-scale immersion lithography and an erbium-doped aluminum oxide layer deposited as the final step in the fabrication process. The large mode size lasers demonstrate single-mode continuo...

In this paper, a fibre laser at 546 nm has been studied for a signal power of -30 dB. Er-doped ZBLAN fibre has been used by upconversion pumping of a 980 nm laser diode. Gain saturation effect has been investigated in detail. Laser performance has also been discussed. An efficiency of 35% has been calculated with a length of 5 mm fibre laser. Results show that Er-doped ZBLAN is a promising cand...

We demonstrate monolithic 160-µm-diameter rare-earth-doped microring lasers using silicon-compatible methods. Pump light injection and laser output coupling are achieved via an integrated silicon nitride waveguide. We measure internal quality factors of up to 3.8 × 105 at 980 nm and 5.7 × 105 at 1550 nm in undoped microrings. In erbium- and ytterbium-doped microrings we observe single-mode 1.5-...

Raman amplification of a 49 cm Bismuth oxide (Bi2O3) as a nonlinear gainmedium based erbium doped fiber amplifier (EDFA) is reported in new and compactdesign in near infrared spectral regions. The bismuth glass host provides theopportunity to be doped heavily with erbium ions to allow a compact optical gain fiberamplifier design by using reduced fiber length and the 1480...