In this work, the construction of a single stage L-band erbium-doped fiber amplifier which incorporates a short 5.1 m erbium doped fiber coil is described. Gain and noise figure measurements as a function of forward, backward and counter-propagating CW 1480 nm pumping schemes at different pump power levels are presented. Further, the Erbium Doped Fiber Amplifier (EDFA) power conversion efficien...

• Understand the principle of operation of the erbium-doped fiber amplifier (EDFA). • Construct an EDFA and an erbium-doped fiber laser. • Measure and calculate the essential parameters of the constructed EDFA. The basic theories on optical amplification by erbium-doped fibers are presented in this section as preparation for the discussions on noise characteristics and noise reduction methods p...

Silica-on-silicon erbium-doped waveguide amplifiers (EDWAs) fabricated by the sol-gel route are demonstrated. The preparation of stable sols is first described, with emphasis on identifying chemical routes that allow the incorporation of sufficient concentration of erbium without precipitation or gelation. Erbium-doped glasses containing various codopants, such as phosphorus, aluminum, germaniu...

Under investigation in this paper is an inhomogeneous nonlinear Schrödinger–Maxwell–Bloch system with variable dispersion and nonlinear effects, which describes the propagation of optical pulses in an inhomogeneous erbium-doped fiber. Under certain coefficient constraints, multi-soliton solutions are obtained by the Hirota method and symbolic computation. Evolution and interaction of the solito...

We demonstrate a high-repetition-rate soliton fiber laser that is based on highly doped anomalously dispersive erbium-doped fiber. By splicing an 11 mm single-mode fiber to the erbium-doped fiber, the thermal damage of the butt-coupled saturable Bragg reflector (SBR) is overcome. The laser generates 187 fs pulses at a repetition rate of 967 MHz with a measured long-term stability of more than 6...

We report, for the first time to our knowledge, the presence of concentration-induced nonuniform power in tunable erbium-doped fiber lasers. A theoretical model is proposed with pair-induced quenching taken into account. We obtain good agreement between numerical and experimental results of a high-concentration erbium-doped fiber ring laser with a large tuning range of over 100 nm. These findin...

We present a new method of measuring the guided, radiated, and total decay rates in uniform waveguides. It is also shown theoretically that large modifications of the total decay rate can be achieved in realistic erbium-doped fiber amplifiers and erbium-doped waveguide amplifiers with effective mode area radii smaller than approximately 1 microm.

In this paper, a brief summary of different methods of fabrication of optical preform and fiber is reviewed. Several methods of incorporation of erbium ions into optical preforms are studied. Characterization of the fabricated erbium doped fibers including measurements of refractive index profile, absorption, fluorescence and gain spectra and metastable lifetime are described. It is also expres...

This paper presents a study of multi-core erbium doped couplers as an alternative to conventional erbium-doped fiber amplifiers. The couplers can reduce the power unbalance between WDM channels along an optical communication link. Different configurations of couplers are analyzed and the influence of the number of cores is studied.

Bulk yttrium oxysulfide phosphors were prepared using the polysulfide flux method. The morphology and structure was characterized using transmission electron microscopy and x-ray powdered diffraction. Visible emissions occurring near 530 and 550 nm and 660 670 nm consistent with the H11/2, S3/2 → I15/2 and F9/2 → I15/2 transitions, respectively, were observed under 808, 980, and 1560 nm excitat...