Mixtures of ethylene glycol and water are used in cooling the engines in automotive applications. To avoid the two-phase flow in the engine, the mixture is subcooled in the radiator before entering the engine block. Heat transfer is therefore essentially under subcooled flow boiling conditions. Very little information is available in the literature on the subcooled flow boiling characteristics ...

The application of Fe–TiO2 photocatalysis using sol–gel method by hot–dipping technique was investigated. Then, the influences of fabrication parameters, molar ratios of Fe to TiO2, the sol temperature, poly ethylene glycol (PEG) content and the number of dipping cycles on the photocatalytic activity in visible light region were mainly studied. The experimental results revealed the sample with ...

Applying partially miscible lubricating oil-refrigerant mixtures instead of completely ones in refrigeration systems is a promising way to avoid the refrigerant insufficiency, and application oil requires clarity nucleate pool boiling characteristics mixtures. As at conditions show an entirely different stratification process compared or non-boiling studied by former researchers, existing resea...

In this study, to improve the heat transfer performance of two-phase immersion cooling with saturated pool boiling using “breathing phenomenon”, we evaluate surfaces composed a lotus copper joined grooved surface various groove sizes in water and FC-72. The critical flux is highest 534 W/cm2 case 1.0-mm-square groove. visualization experiments demonstrated that breathing phenomenon expected be ...

Controlling boiling incipience is of paramount importance for reliable operation of liquid-cooled microelectronic heat sources during power transients. This study focuses on heat transfer from a simulated multichip module to a falling film. Experiments have been performed to develop an understanding of the influence of surface tension and wetting characteristics on sensible heat transfer and bo...

As is well known, boiling is an effective mode of heat transfer in that high heat flux levels are possible with relatively small temperature differences. Its optimal application requires that the process be adequately understood. A measure of the understanding of any physical event lies in the ability to predict its behavior in terms of the relevant paramem. Despite many years of research the p...

Boiling is a very efficient way to transfer heat from a heater to the liquid carrier. We discuss the boiling crisis, a transition between two regimes of boiling: nucleate and film boiling. The boiling crisis results in a sharp decrease in the heat transfer rate, which can cause a major accident in industrial heat exchangers. In this communication, we present a physical model of the boiling cris...

Flow boiling in microchannels has received considerable attention from researchers worldwide in the last decade. A scaling analysis is presented to identify the relative effects of different forces on the boiling process at microscale. Based on this scaling analysis, the flow pattern transitions and stability for flow boiling of water and FC-77 are evaluated. From the insight gained through the...

Transient nucleate pool boiling experiments using R113 are conducted for short times in microgravity and in earth gravity with different heater surface orientations and subcoolings. The heating surface is a transparent gold film sputtered on a quartz substrate, which simultaneously provides surface temperature measurements and permits viewing of the boiling process from beneath. For the microgr...