The effect of friction in the thermal convection instability of granular fluids is studied by means of molecular dynamics simulations. It is found that the transitions between different convective states (zero, one, and two rolls) are primarily governed by the average energy loss per collisions and not by the friction and restitution coefficients separately, and can be roughly described in term...

Butterfly valve is a flow control device, which is used to regulate the fluid flowing through a piping system. Analysis and optimization are of special importance in the design and usage of butterfly valves. A proper selection of a Butterfly valve would require the knowledge of its characteristics and robustness. Normally this information used to be obtained from experimental tests. However the...

Flow characteristics of low Reynolds number laminar flow through gradually expanding conical and planar diffusers were investigated. Such diffusers are used in valveless micropumps to effect flow rectification and thus lead to pumping action in one preferential direction. Four different types of diffuser flows are considered: fully developed and thin inlet boundary layer flows through conical a...

Measurements of heat collection rate and heat loss coefficient are crucial for the evaluation of in service water-in-glass evacuated tube solar water heaters. However, conventional measurement requires expensive detection devices and undergoes a series of complicated procedures. To simplify the measurement and reduce the cost, software based on artificial neural networks for measuring heat coll...

In the present investigation the distribution of mean velocity, static pressure and total pressure are experimentally studied on an annular curved diffuser of 37.5° angle of turn with an area ratio of 1.284 and centerline length was chosen as three times of inlet diameter. The experimental results then were numerically validated with the help of Fluent and then a series of parametric investigat...

In the present investigation the distribution of mean velocity, static pressure and total pressure are experimentally studied on a C-shape diffuser of 40° angle of turn with an area ratio of 1.278 and centerline length was chosen as three times of inlet diameter. The experimental results then were numerically validated with the help of Fluent and then a series of parametric investigations are c...

The determinations of heat collection rate and heat loss coefficient are crucial for the evaluation of in service water-in-glass evacuated tube solar water heaters. However, the direct determination requires complex detection devices and a series of standard experiments, which also wastes too much time and manpower. To address this problem, we propose machine learning models including artificia...