Current experimental investigation deals with the effects of asymmetrical rolling parameters on the inhomogeneity, microstructure, mechanical, and geometrical properties of rolled brass wire. Toward this end, a roll machine with three different roll radii ratios was set up. The asymmetrical conditions are arranged using three different sets of rolls with different diameters that result into dif...

In this paper, an analytical model based on Modified Slab Method is presented for rolling of clad sheet or double-layers in which the two layers are bounded prior to rolling. This model considers the general case of asymmetrical rolling due to unequal &#10surface speed, different contact friction, roll diameters, flow stress, and thickness ratios of the two layers. Using this model, rolling par...

In this paper, an analytical model based on Modified Slab Method is presented for rolling of clad sheet or double-layers in which the two layers are bounded prior to rolling. This model considers the general case of asymmetrical rolling due to unequal surface speed, different contact friction, roll diameters, flow stress, and thickness ratios of the two layers. Using this model, rolling param...

This contribution deals with the modeling and control of flatness defects in form of so–called ski–ends which occur during the hot rolling process of heavy plates. These ski–ends are caused by asymmetrical rolling conditions, e.g., different work roll circumferential speeds or vertical temperature gradients. In a first step, a physics–based model for asymmetrical rolling is derived based on the...

In this paper, an analytical method based on Modified Slab Method of analysis is presented to study the asymmetrical rolling process due to difference in work rolls radii, rolls speeds and interface frictions. The shear force imposed on material along the contact region is considered to be a function of the frictional factor and the roll gap geometry. Elastic-plastic with linear work hardening ...

In this paper, an analytical method based on Modified Slab Method of analysis is presented to study the asymmetrical rolling process due to difference in work rolls radii, rolls speeds and interface frictions. The shear force imposed on material along the contact region is considered to be a function of the frictional factor and the roll gap geometry. Elastic-plastic with linear work hardening ...

Rolling bearing is main part of rotary machine. It is frail section of rotary machine. Its running status affects entire mechanical equipment system performance directly. Vibration acceleration signals of the third finishing mill of Anshan Steel and Iron Group wire plant were collected in this paper. Fourier analysis, power spectrum analysis and wavelet transform were made on collected signals....

The secondary instabilities in the wake of a circular cylinder with near-wake wire disturbances are investigated by using threedimensional (3D) direct numerical simulations (DNS). For one wire placed asymmetrical about the wake centreline and two wires placed symmetrical about the wake centreline, the secondary instabilities are found to be Mode C and Mode A, respectively. The existence of the ...

The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...