A series of Fe–Ce–Ti catalysts were prepared via co-precipitation method to investigate the effect of doping Ce into Fe–Ti catalysts for selective catalytic reduction of NO with NH3. The NO conversion over Fe–Ce–Ti catalysts was considerably improved after Ce doping compared to that of Fe–Ti catalysts. The Fe(0.2)–Ce(0.4)–Ti catalysts exhibited superior catalytic activity to that of Fe(0.2)–Ti ...

the kinetic of fischer-tropsch synthesis over a co-precipitated fe-ce catalyst was investigated in a fixed bed micro reactor. experimental conditions were varied as follow: reaction pressure 1-15bar, h¬¬¬2/co feed ratio of 1-3 and space velocity of 3600-5400 h-1 at the temperature range of 270-310°c. 4 models according to the langmuir-hinshelwood-hougen-watson (lhhw) type rate equation were der...

The catalysts of iron-doped Mn-Ce/TiO2 (Fe-Mn-Ce/TiO2) prepared by sol-gel method were investigated for low temperature selective catalytic reduction (SCR) of NO with NH3. It was found that the NO conversion over Fe-Mn-Ce/TiO2 was obviously improved after iron doping compared with that over Mn-Ce/TiO2. Fe-Mn-Ce/TiO2 with the molar ratio of Fe/Ti = 0.1 exhibited the highest activity. The results...

In this study, ternary mixed metal oxide (Ce2O3/La2O3/Fe3O4) catalysts were synthesized for reduction of SO2 to sulfur by CH4. The response surface method (RSM) was used to optimize the synthesis conditions. The XRD, FESEM, BET, BJH, EDX and NH3-TPD analyses were performed to characterize the synt...

It was found that the periodic change of the solution viscosity and density was generated in the Belousov-Zhabotinsky (BZ) reaction. This rhythmic phenomenon was observed in both the iron catalyst [[Fe(Phen)(3)](2+)-[Fe(Phen)(3)](3+)] and the cerium catalyst [Ce(III)-Ce(IV)] system, where the solution viscosity and density were synchronized with the redox potential in the in-phase mode. However...

We report dynamic alternation of the redox chemistry of the Fe/ Fe couple in magnetite during high temperature water−gas shift reaction in Cu codoped Mmodified ferrite catalysts. Various hematitic solid solutions of the type Fe2O3−MxOy−CuOx with M = Cr, Ce, Ni, Co, Mn, and Zn are synthesized using the industrially economical and environmentally friendly coprecipitation method. Interestingly, Cu...

Using wet impregnation method, a novel ternary system of silica supported Fe-Co-Ce catalyst was prepared. Preparation conditions such as impregnation time and temperature, drying time and temperature, were optimized by the L9 Taguchi experimental design to achieve a light olefin selective catalyst with maximum CO conversion in a fixed bed micro-reactor. It was found that the best conditions to ...

Fe–Cu–ZSM-5 and Ce–Fe–Cu–ZSM-5 solids prepared using solid-state ion exchange method (SSIE) were tested in the NH3–SCR of NO reaction characterized N2 physisorption at 77 K, MAS 27Al magnetic resonance, X-ray diffraction, scanning electron microscopy, EPR spectroscopy transmission microscopy coupled to energy-dispersive order follow effect Ce addition on textural structural properties Fe–Cu–MFI...

In this work the development of gold catalysts, essentially based on γ-alumina with small superficial fraction of Ce-Fe mixed oxides as support for the low temperature CO oxidation is proposed. Characterization results obtained by means of TEM, OSC, XPS, UV-Vis spectroscopy and H2-TPR are employed to correlate the activity data with the catalysts composition. The bare γ-alumina supported gold c...

Novel K-promoted bimetallic Fe- and In-based catalysts on a Ce? ZrO2 support were prepared tested for higher alcohol synthesis from CO2 hydrogen. The FeIn/Ce?ZrO2 precursors with different Fe contents characterized in detail, well-dispersed Fe2O3 In2O3 phases oxygen vacancies observed. continuous setup at extended times stream (up to 100 h) 300 °C, 10 MPa, gas hourly space velocity of 4500 mL g...