different methods have been evaluated for manufacturing the porous ti6al4v alloys according todecreasing stress shielding phenomenon and increasing mechanical compatibility between themetallic components and the host tissue. for this purpose, in this work ti6al4v alloy chips werepressed under 400 mpa pressure and then samples were categorized and heated into two groups at1000 and 1150℃ under a ...

In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

Recycling of aluminum alloys often decrease fluidity, consequently influence the castability of the alloy. In this study, the fluidity of Al-Zn alloys, such as the standard A713 alloy with and without scrap addition has been investigated. The scrap added was comprised of contaminated alloy turning chips. Fluidity measurements were performed with double spiral fluidity test consisting of gravity...

Current work elaborates possibilities for direct conversion of AlMgSi1 aluminium chips into solid billets by solid state recycling. Milling chips from an aluminium alloy were cold compressed in a closed cylindrical die by means of a 2,5 MN hydraulic press. Due to low initial relative density of the chips, several pre-compressions were needed. In order to establish the infl uence of chip geometr...

In machining of Ti-6Al-4V alloy, the formation of saw tooth chips takes place at relatively low cutting speeds in comparison to other materials such as hardened steels. Study of chip morphology is important to understand the cutting force variation, surface integrity and chip breakability of the alloy. In this work, an attempt has been made to study the effect of cutting speed, feed rate and de...

Different methods have been evaluated for manufacturing the porous Ti6Al4V alloys according to decreasing stress shielding phenomenon and increasing mechanical compatibility between the metallic components and the host tissue. For this purpose, in this work Ti6Al4V alloy chips were pressed under 400 MPa pressure and then samples were categorized and heated into two groups at 1000 and 1150℃ unde...

Different methods have been evaluated for manufacturing the porous Ti6Al4V alloys according to decreasing stress shielding phenomenon and increasing mechanical compatibility between the metallic components and the host tissue. For this purpose, in this work Ti6Al4V alloy chips were pressed under 400 MPa pressure and then samples were categorized and heated into two groups at 1000 and 1150℃ unde...