Over the last ten years, robustness of schemes has raised an increasing interest among the CFD community. The objective of this article is to solve the quasi-one-dimensional compressible flow inside a “Shubin nozzle” and to investigate Bean-Warming and flux vector splitting methods for numerical solution of compressible flows. Two different conditions have been considered: first, there is a sup...

over the last ten years, robustness of schemes has raised an increasing interest among the cfd community. the objective of this article is to solve the quasi-one-dimensional compressible flow inside a “shubin nozzle” and to investigate bean-warming and flux vector splitting methods for numerical solution of compressible flows. two different conditions have been considered: first, there is a sup...

In this article, turbulent flow heat transfer in the air gap between rotor and stator of a generator under nonhomogeneous heat flux is studied experimentally. The rotor consists of four symmetrical triangular grooves. The stator surface is smooth and does not include any grooves. The relative heat flux between the rotor and the stator is 1 to 3. Temperature and heat flux are measured locally at...

in this study, the dispersion mechanisms of aerosols suspended in a turbulent plane channel flow is investigated using a novel numerical approach. a turbulent channel flow is simulated by a direct numerical simulation (dns) method, for which no-slip boundary conditions are assumed at the top and bottom walls, while periodicity conditions are applied on the other sides. dns, in particular, allow...

his investigation was carried out to reveal the impact of solar radiation on wind flow structure and pollutant dispersion in an urban street canyon of aspect ratio of one using the computational fluid dynamic (cfd) technique. the simulation results (velocity and concentration data) show that heating from building wall surfaces and ground lead to strong buoyancy forces as the air is heated by th...

In this article, turbulent flow heat transfer in the air gap between rotor and stator of a generator under nonhomogeneous heat flux is studied experimentally. The rotor consists of four symmetrical triangular grooves. The stator surface is smooth and does not include any grooves. The relative heat flux between the rotor and the stator is 1 to 3. Temperature and heat flux are measured locally at...

In this work, the effects of permeate pressure and feed flow rate on the performance of a composite polyvinyl alcohol (PVA) membrane in the removal of benzene from gasoline by pervaporation (PV) were evaluated. The results indicate the remarkable effect of permeate pressure on membrane performance as reducing permeate pressure (higher vacuum) from 30 to 3 mmHg causes the total flux to increase ...

In this work, sweeping gas membrane distillation (SGMD) process was used for concentrating of glucose syrup. The main questions in this work include: is SGMD process practical for concentrating of glucose solution prior the fermentation step in bioethanol process?. and are the commercially available hydrophobic membranes sufficient enough to develop the SGMD process in pilot scale for this issu...

In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...