The friction welding of Zr55Al10Ni5Cu30 bulk metallic glasses (BMG) has been tried. An apparatus for the friction welding of BMGs adopting a pneumatic cylinder and gripper based on a conventional lathe, and a welding process which provides a sufficient cooling rate after welding were devised. Friction time and friction pressure were chosen as the control parameters in the friction welding proce...

Aim: To evaluate the effect of ligation method on friction and the efficacy of the new slick elastomeric modules (TP Orthodontics, USA) and slide elastomeric modules (Leone Orthodontics, Italy) which claim to reduce friction at the module/wire interface. Materials and methods: Slick and slide modules were compared with regular modules, modules tied in figure of eight fashion, tight stainless st...

Orthodontic tooth movement can be regarded as teeth sliding on a wire like pearls on a string, the force being supplied by springs or elastics. The movement implies friction between wire and bracket, taking up part of the force and leaving an uncontrolled amount to act on the teeth. The friction is likely to depend on bracket construction and wire material. Therefore, in this investigation the ...

We demonstrate measurement and control of nanoscale single-asperity friction by using cantilever probes featuring an in situ solid-state heater in contact with silicon oxide substrates. The heater temperature was varied between 25 and 790 °C. By using a low thermal conductivity sample, silicon oxide, we are able to vary tip temperatures over a broad range from 25 ± 2 to 255 ± 25 °C. In ambient ...

In this paper, we investigate the sliding friction and wear behavior of a hydrogenated diamond-like carbon (DLC) film in ultrahigh vacuum (UHV) and under partial pressures of water vapor, oxygen, nitrogen and hydrogen. The initial friction coefficient of the film in UHV was 0.15, but decreased steadily to values as low as 0.03 after about 30 sliding passes. During longer duration tests, the fri...

To clarify the friction durability, both during and after the high-temperature heating of nanometer-thick diamond-like carbon (DLC) films, deposited using filtered cathodic vacuum arc (FCVA) and plasma chemical vapor deposition (P-CVD) methods, the dependence of the friction coefficient on the load and sliding cycles of the DLC films, were evaluated. Cluster-I consisted of a low friction area i...

the influence of surface roughness magnitude and direction on dry static friction coefficient between two similar steel samples has been studied through an experiment. a testing apparatus has been designed and fabricated to measure the friction coefficient for a few forms of surface asperity. according to the results of the experiments, dry friction coefficient is affected by both magnitude and...

Discussions of energy dissipation during friction processes have captured the attention of engineers and scientists for over 300 years. Why then do we know so little about either dissipation or friction processes? A simple answer is that we cannot see what is taking place at the interface during sliding. Recently, however, devices such as the atomic force microscope have been used to perform fr...

Angled polyurethane fiber arrays are modified by adding soft spherical and spatula shaped tips via dipping. These fibers are characterized for adhesion and friction and compared with unmodified fibers and flat material samples. Sphere and spatula tip fiber samples demonstrate increased adhesion, with 10 and 23 times the maximum adhesion of the unmodified fiber sample, respectively. The sphere a...

In this paper we present two controllers for robots that combine terms for the compensation of gravity forces, and the forces of friction of motors and gearboxes. The Low-Friction Zero-Gravity controller allows a guidance of the robot without effort, allowing small friction forces to reduce the free robot motion. It can serve to aid users providing kinesthetic demonstrations while programming b...