The purpose of the hot rolling mill is to make a preheated steel block thinner and longer, see Figure 1. This is done by pulling the plate through two parallel rolls mounted in the rolling mill. Due to the large forces obtained in hot rolling, the elastic de ection of the rolling mill is of the same order of magnitude as the plate thickness. Variations in the rolling force caused by variations ...

This paper presents an optimization approach to deal with the problem of minimizing the hot rolling time of a steel slab. Unlike traditional approaches, this work also considers the chemical composition of the steel slab as a parameter, allowing the automatic setup for different steels of the hot rolling mill. To validate the approach discussed here, a six-stand rolling mill is modeled as an op...

The application of Generalised Predictive Control (GPC) for an experimental hot-rolling mill is presented in this paper. GPC has been implemented to provide the mill with good speed control and regulation when steel and aluminium hot-rolling experiments are carried out. Using an identification mechanism, GPC first estimates the mill’s model and predict the future behaviour of the rolling speed ...

Hydraulic bending roll system has become one of key equipments to control the exit strip shape in strip rolling mills. The hydraulic bending roll system of a hot rolling mill was researched and analyzed, and its mathematics models were founded in whole based on the action principle of some representative hydraulic components. At last, the hydraulic bending roll system was simulated with MATLAB ...

The decrease in hot strength or even rolling load as strain increases in some stands of the finishing hot strip mill with no metallurgical reasons is a relatively common event. Apparently this fact is associated with modification in the tribological conditions between rolling stock and work roll surfaces due to unexpected interactions with scale. The aim of this work was to determine the values...

It is not rare to observe an inverse relationship between hot strength determined from rolling load of the finishing stands of the hot strip mill and strain. This situation was already described in the literature and is explained by the use of inverse rolling load models that assumes sticking friction in the determination of hot strength. The aim of this work was to show that this “work softeni...

The authors discuss the combination of an Artificial Neural Network (ANN) with analytical models to improve the performance of the prediction model of finishing rolling force in hot strip rolling mill process. The suggested model was implemented using Bayesian Evidence based training algorithm. It was found that the Bayesian Evidence based approach provided a superior and smoother fit to the re...

key account business analyst, Quaker Chemical Corp., Conshohocken, Pa., USA [email protected] Nucor Steel Tuscaloosa Inc. is the first U.S. mill to employ Steckel mill technology for producing high-quality wide coiled plates and discrete plates. Since 1985, the Steckel mill has consistently demonstrated product versatility, quality and cost advantage over traditional plate mills. The single...

This paper describes the design, implementation and testing of an intelligent knowledgebased supervisory control (IKBSC) system for a hot rolling mill process. A novel architecture is used to integrate an expert system with an existing supervisory control system and a new optimization methodology for scheduling the soaking pits in which the material is heated prior to rolling. The resulting IKB...

This paper is concerned with investigations into the effect of tension between the stands of the finishing mill on width control in a hot rolling process. An analysis is given to predict satisfactorily the variation in width due to spreading and also due to strip tension between the stands. Wusatowski's model which is developed to give an account of spreading is specified and a similar model to...