the abrasive flow machining technique uses a self-deforming tool, an abrasive laden media that is passed back and forth in the passage geometry of the hollow workpiece with the assistance of two hydraulically operated cylinders placed opposite to each other. the material is removed by abrasion generating finer surfaces in the area where flow is restricted. but this method has a low material rem...

the existing studies of threshing process of combine harvesters adopt the assumption of constant mass, which is contradictory to the phenomenon of separation of grains and short stalks in actual threshing process. therefore, the characteristics of threshing and separation are not accurately described. aiming at this problem, this study established the tangential-longitudinal threshing and separ...

one of the most important issues in the plant layout design especially in mass production organizations with high inter-plant logistics is‘material flow and inter-plant traffic analysis and its effects on the production capabilities or pauses in production lines. in this paper the inter-plant traffic analysis issue on the basis of single channel queue model (m/m/1) is analyzed in a carmaker c...

in this study, using sound created by wheat grain passing through a pipe, wheat flow rate was measured. the developed device consists of a hopper, metering device, sound sensor, delivery tube, dc motor and power supply. several wheat mass flow rates were tested and the sound signal created by the passage of the grain through the discharge tube was measured and transferred to a computer using da...

The need to improve the access to safe water is generally recognized for the benefit of public health in developing countries. This study's objective was to identify critical parameters which are essential for improving the performance of ceramic pot filters (CPFs) as a point-of-use water treatment system. Defining critical production parameters was also relevant to confirm that CPFs with high-...

The experimental investigation of material flow in rotary drums is studied. An equipment in the size of pilot-scale was used to collect experimental data for investigation of validity of the conventional steady-state model of material flow in rotary drums. Also, the transient data of the time required for material movement in the empty drum up to any specified cross section are also reported. T...