By taking advantage of bacterial extracellular electron transfer behavior, a facile method was developed to fabricate oriented polypyrrole micro-pillars (PPy-MP) with nanoscale surface roughness. Microbes acted as a living conductive template on which PPy was in situ polymerized. The as-prepared PPy-MP exhibit the distinctive underwater low adhesive superoleophobicity which is attributable to t...

Multifunctional nano-platform for the combination of photo-based therapy and photoacoustic imaging (PAI) for cancer treatment has recently attracted much attention to nanotechnology development. In this study, we developed iron-platinum nanoparticles (FePt NPs) with the polypyrrole (PPy) coating as novel agents for combined photothermal therapy (PTT) and PAI. The obtained PPy-coated FePt NPs (F...

Nanometric field-effect-transistor (FET) sensors are made on the tip of spear-shaped dual carbon nanoelectrodes derived from carbon deposition inside double-barrel nanopipettes. The easy fabrication route allows deposition of semiconductors or conducting polymers to comprise the transistor channel. A channel from electrodeposited poly pyrrole (PPy) exhibits high sensitivity toward pH changes. T...

This article applies the standard deviation of partial signal (SDPS) plots of electrochemical noise (EN) current signals originating from corrosion events on the symmetrical and asymmetrical electrodes made of uncoated and polypyrrole (PPy)-coated mild steel alloy in 4000 ppm NaCl+1000 ppm NaNO2 solution. Signal recording was performed after 30, 60, 90 min and 24 h from immersion...

Nano-conducting copolymers of aniline (ANI) and pyrrole (Py) with silica of different starting monomer ratios are prepared by oxidative chemical polymerization. X-ray diffraction (XRD) data showed that polyaniline (PANI) is the predominant phase in copolymer composites with a higher starting ANI monomer ratio while polypyrrole (PPy) is the major phase for other prepared samples. Transmission an...

The development of high-surface-area carbon electrodes with a defined pore size distribution and the incorporation of pseudo-active materials to optimize the overall capacitance and conductivity without destroying the stability are at present important research areas. Composite electrodes of carbon nano-onions (CNOs) and polypyrrole (Ppy) were fabricated to improve the specific capacitance of a...

An in vitro comparison of conducting-polymer nanotubes of poly(3,4-ethylenedioxythiophene) (PEDOT) and poly(pyrrole) (PPy) and to their film counterparts is reported. Impedance, charge-capacity density (CCD), tendency towards delamination, and neurite outgrowth are compared. For the same deposition charge density, PPy films and nanotubes grow relatively faster vertically, while PEDOT films and ...

The state-of-the-art diabetes diagnosis is concerned with developing non-invasive nano-enabled exhaled breath-acetone detection strategies. This communication details the potential of polypyrrole(PPy)– Silver/silver chloride (Ag/AgCl) ternary nanocomposites (NCs) for monitoring low-trace acetone in human breath diagnosis. PPy–Ag/AgCl NCs were synthesized through situ chemical oxidative polymeri...

polypyrrole is one of the most useful conductive polymers, but green synthesis of this polymer has been restricted until now. the objective of the present paper is green synthesis of nano polypyrrole (ppy) by oxidative polymerization using urea-hydrogen peroxide. it was found that conductivity and morphology of polypyrrole are highly dependent on the reaction conditions such as the molar ratio ...

The present study seeks to investigate the capacity of polyaniline/titanium dioxide (PAn/TiO2) and Polypyrrole/titanium dioxide (PPy/TiO2) nano-adsorbents to adsorb Congo red anionic dye (CR) from aqueous solution. The variables effective in CR adsorption, including adsorbent dose, pH of the solution, contact time, initial dye concentration, and temperature were examined. The study yielded the ...