the thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (b/h=0.5-1.75) atdifferent reynolds numbers, ranging from 6000 to 18000. the capability of differentturbulence models, including standard k-ε, rng k-ε, standard k-ω, and sst k-ω, inpredicting the heat transfer rate was compared with the experi...

A STUDY OF IMMERSED BOUNDARY METHOD IN A RIBBED DUCT FOR THE INTERNAL COOLING OF TURBINE BLADES Long He Abstract In this dissertation, Immersed Boundary Method (IBM) is evaluated in ribbed duct geometries to show the potential of simulating complex geometry with a simple structured grid. IBM is first investigated in well-accepted benchmark cases: channel flow and pipe flow with circular crossse...

The present work is carried out to investigate heat transfer and friction factor characteristics of fluid (air) flow through turbulent channel i.e. parallel plate heat exchanger for different geometry and designs parameters, with a bottom plate applied to uniform constant heat flux thermal boundary condition, and upper plate is provided with a insulated condition. The fluid domain is designed u...

Controversial views have been expressed about whether tarantula feet can secrete fine silk threads that could prevent them from falling off smooth vertical surfaces. Two studies have claimed that 'ribbed hairs' on the tarsi of tarantulas produce silk. We examined these ribbed hairs in several tarantula species using light and scanning electron microscopy, and compared them with the silk-produci...

Increasing the turbine inlet temperature can increase the gas turbine cycle efficiency. In order to increase the turbine inlet temperature significantly, an advanced cooling system has to be essentially developed. Injection of mist to the coolant fluid is considered a promising technique to protect the hot components such as combustor liners, combustor transition pieces, and turbine vanes and b...

Multi-ribbed frame grid (hereinafter referred to as MRFG) is an important part of Multi-ribbed composite wall and consisted of outer frame and ribbed grid. The reinforcement of outer frame is the main influence factor on the performance of MRFG. In this study, an MRFG specimen under laterally cyclic and axial loading in literature is numerically simulated with 5 kinds of different reinforcement...

In order to study the basic mechanical property of cast-in-place stiffening-ribbed-hollow-pipe reinforced concrete girderless floor, and similarities and differences of the structural performance compared with traditional floor, we carried out the destructive stage loading test on the short-term load test of floor model with four clamped edges supported in large scale, and conducted the long-te...

Roughness elements or turbulence promoters have been widely used to enhance heat transfer in cooling passages of modern gas turbine blades. Although such ribs substantially enhance heat transfer, the heat transfer coefficient is reduced immediately at corner downstream of each rib, creating hot spots. To remove such hot spots some of the ribs can be detached from the channel walls. In this pape...

According to the actual working conditions of the Vribbed belt, automobile V-ribbed belt fatigue tester machine is designed to test for the automobile engine Vribbed belt fatigue wear. Finite-element analysis software ANSYS is employed to perform finite-element analysis on fatigue testing machine load shaft, bearing, universal joint key parts of the finite-element analysis, and to analyze the m...

Abstract The paper presents the solution of conjugated heat exchange problem in a cylindrical ribbed tube using open integrated platform OpenFOAM. obtained results allow estimating fluid heating along channel as well temperature difference on walls tube. It is shown that minimum observed center tube, and maximum one closer to walls.