The fundamental frequencies and mode shapes of steel and carbon fiber–reinforced plastic (CFRP) cylindrical shells with steel inserts were investigated using finite element analysis and modal testing. The free-free boundary condition was tested with modal testing using the roving hammer method and verified by finite element analysis using ABAQUS. The results show good agreement between the test...

At BAM, the Federal Institute for Materials Research and Testing, a group of scientists develops NDTapplications based on GMR sensor technology. In particular, the knowledge gained in the field of automated testing systems based on the magnetic flux leakage (MFL) were combined with GMR sensors to achieve high resolution testing of ferromagnetic materials. In cooperation with Europe’s second lar...

S. Rešković, I. Jandrlić, University of Zagreb, Faculty of Metallurgy, Sisak, Croatia, F. Vodopivec Institute of Metals and Technology, Ljubljana, Slovenia Using thermal imaging camera during tensile testing of low carbon and Nb microalloyed steel influence of testing rate on start of plastic deformation was investigated. The results showed that the onset of plastic flow is significantly differ...

Calibration and Reference Blocks ................................................................. 7 Longitudinal Wave Probes ............................................................................. 7 Transverse Wave Probes ............................................................................. 10 Measurement of Steel Thickness ...........................................................

Microstructural and mechanical properties of precipitation-hardened maraging steel could be stated on a basis of magnetic properties of such a material. A correlation between mechanical and magnetic properties of the maraging steel is treated from the view of non-destructive testing during and after heat treatment as well as during use under unfavourable conditions at elevated operating tempera...

Steel manufacturers conduct quality control testing for a range of metals and trace elements to ensure the grade and performance of their final product. The Standardization Administration of China uses their GB/T 20125-2006 standard “Low-alloy steel – Determination of multi-element contents – Inductively coupled plasma atomic emission spectrometric method” to control the quality of manufactured...

Internal stress in structural steel members is an important parameter for steel structures in their design, construction, and service stages. However, it is hard to measure via traditional approaches. Among the existing non-destructive testing (NDT) methods, the ultrasonic method has received the most research attention. Longitudinal critically refracted (Lcr) waves, which propagate parallel to...

the use of twb has been developed in automotive industries because of it’s advantages such as reduction in weight, cost and fuel economy of vehicles. the main objective of the peresent work is to study the effects of weld zone, diffrence in surface coating and thickness ratio on the formability of twb composed of aisi 304, spcc and if steel sheets. it was found that the narrow weld zone has lit...

Performance-based fire design for cold-formed steel systems is in its infancy. This paper brings together existing research on cold-formed steel materials, members, and assemblages at elevated temperatures; and complementary analysis and design methods necessary for the development of analysis-based design for cold-formed steel systems under fire. Cold-formed steel systems have become popular i...

In inspecting steel-rubber multi-layered structure, shielding of steel layer and intense attenuation of rubber layer result in ultrasonic echo from the interfaces of the deep layers being very weak. In order to overcome the difficulty, the double mode testing method is put forward. This method synthesizes the characteristics of transverse wave and Lamb wave testing. In the double modetesting tr...