due to the high efficiency and low switching losses of resonant power convertors in comparison with switching convertors, nowadays there is a growing trend towards these convertors. however, because of the high frequency of switching in such convertors, it is quite difficult to present an efficient control method. in this paper, based on the state feedback method and using pole placement techni...

VAR support should be supplied as close to the load as possible to minimize transmission losses. For voltage control and for improvement of total power factor in a distribution system the circuit- breaker switched capacitor banks can be used. The problems with this solution are the voltage steps caused by the large sizes of the capacitor banks as well as the transients caused on insertion. Thyr...

Multilevel inverters are emerging as a most promising alternative for reducing the harmonics and to achieve high-voltage, high-power capability but switching losses are increased because of increased device count. Many modulation techniques like soft switching techniques, space vector-based PWM techniques or sinusoidal PWM-based techniques were employed to reduce the switching losses. In this p...

In this paper an efficient high step-up converter with a coupled- inductor with soft- switching operation is presented. The proposed topology includes a coupled-inductor boost converter for raising the voltage gain. Moreover, a simple auxiliary resonant circuit composed of an auxiliary switch, a clamping diode and a resonant tank (inductor, capacitor), is adopted in this paper. The coupled-indu...

This paper corroborates three different hybrid modulation strategies suitable for single-phase voltage source inverter. The proposed method is formulated using fundamental switching and carrier based pulse width modulation methods. The main tale of this proposed method is to optimize a specific performance criterion, such as minimization of the total harmonic distortion (THD), lower order harmo...

Optimal placement of switching devices is a very important for distribution networks‟ planning, operation and cost minimization. Further identifying optimal placement of switches is typical if the distribution system consists of Distributed Generators (DGs). Generally DGs are used to reduce the losses, to improve the voltage profile and to increase the reliability of the system. Further in orde...

this paper presents a novel control method to improve the efficiency of low-voltage dc-dc converters at light loads. pulse width modulation (pwm) converters have poor efficiencies at light loads, while pulse frequency modulation (pfm) control is more efficient for the same cases. switching losses constitute a major portion of the total power loss at light loads. to decrease the switching losses...