asymmetric polyethersulfone (pes) microfiltration flat sheet membranes were composed by the phase inversion method (pim) and were used as supports. composite membranes were fabricated by coating silicone rubber as selective layer. effect of different concentrations of pes and pdms and different solvent such as nmp, dmf and dms effects as pes solvents and support thickness and different coagulat...

the methods which are used to analyze microstrip antennas, are divited into three categories: empirical methods, semi-empirical methods and full-wave analysis. empirical and semi-empirical methods are generally based on some fundamental simplifying assumptions about quality of surface current distribution and substrate thickness. thses simplificatioms cause low accuracy in field evaluation. ful...

gol-e-gohar iron ore mine of sirjan in southern part of iran is a large open pit that operates below the groundwater table and during mining operation, dewatering is required to prevent operation processes from flooding. current operation is going on by digging wells in or out of the pit and pumping to prevent flooding. as a result of the former dewatering operation a vast deep cone of depressi...

run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...

thermal barrier coatings (tbcs) are used to provide thermal insulation to the hot section components of gas turbines in order to enhance the operating temperature and turbine efficiency. hot corrosion and thermal shocks are the main destructive factors in tbcs which comes as a result of oxygen and molten salt diffusion into the coating. in this thesis atmospheric plasma spraying was used to dep...

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

one of the most commonly used techniques to reduce the corrosion rate of rebar in concrete is addition substances named corrosion inhibitors into the concrete. corrosion inhibitor is chemical compounds that were added to concrete to prevent corrosion of steel in concrete. sodium nitrate is a type of anodic inhibitors that this study investigatesthe effect of this inhibitor on the properties of ...

rivers and runoff have always been of interest to human beings. in order to make use of the proper water resources, human societies, industrial and agricultural centers, etc. have usually been established near rivers. as the time goes on, these societies developed, and therefore water resources were extracted more and more. consequently, conditions of water quality of the rivers experienced rap...