numerical and experimental analyses are performed on multilouvered fin banks in low and medium reynolds regimes to investigate the effects of dimples and perforations on flow structure and heat transfer capacity. in different reynolds numbers the flow efficiency has been calculated numerically and experimentally by flow visualization method and the results showed that dimples and perforations c...

heat transfer phenomena in batch fluidized bed dryer have been studied and analyzed using three phase model including solid phase, interstitial gas phase and bubble phase based on rizzi model. new correlations of heat transfer coefficient to surrounding and convection heat transfer coefficient between solid and interstitial gas are being proposed. in addition, some modifications have been done ...

most previous laboratory studies of local scour at bridge abutments were performed in rectangular channels in which the distributions of flow velocity and bed shear stress were considered uniform in the transverse direction. in reality however, bridge abutments are usually located in the floodplain zone of rivers where velocity and shear stress distributions are directly affected by the lat...

ipr owners have a right about voluntary transfer but sometimes intellectual property right transfer by force and thus, there are challenge that this article regard for its. ipr shall be devolved to their legitimate heirs after their death unless, owner indicate otherwise in their wills. the heirs have the exclusive right to exercise economic and moral rights, they decide upon publication of the...

 Abstract: This paper presents the results of an experimental examination of the effect of non-uniform wall temperature on local heat transfer coefficient in a rotating smooth-walled square channel. Three different thermal boundary situations were investigated: (a) even and odd (four) wall uniform temperature, (b) even and odd (four) wall uniform heat flux, and (c) even (leading and trailing) w...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

Heat Transfer has special importance in engineering applications. So, researchers have suggested different new idea to increase heat transfer and using nanofluid is one of these methods In recent years, new methods have been used. One of these methods is the use of nanofluids, ., because nanofluids have higher heat transfer potential than base conventional fluids. In this investigation effect o...

An experimental investigation was conducted to study the average and the fully-developed heat (mass) transfer coefficients in a rectangular smooth duct and a duct with repeated-baffle blockages. The focus of attention in this work is the conventional correlation Nu / Nufd 1 + C / ( X / D ) for the average heat transfer coefficient. It was shown that for relatively short ducts, the coefficient C...

Neural network is one of the new soft computing methods commonly used for prediction of the thermodynamic properties of pure fluids and mixtures. In this study, we have used this soft computing method to predict the coefficients of the Antoine vapor pressure equation. Three transfer functions of tan-sigmoid (tansig), log-sigmoid (logsig), and linear were used to evaluate the performance of diff...