Current commercial interferometers reveal excellent measurement performances, because of its major advantage which enables the displacement measurement with the characterization of the high resolution under the large measuring range. FabryPerot interferometer is a compact interferometer with the structure of common optical path. In comparison with the ordinary commercial laser interferometers h...

Due to its high resolution and the large measuring range, laser interferometer has been applied widely to the precision industrial measurement and calibration. Fabry-Perot interferometry was often used for the microdisplacement, because of its common optical path structure being insensitive to the environmental disturbances. In the past researches, some kinds of modified Fabry-Perot interferome...

Optical sensors based on Fabry-Perot interferometer to detect cadmium ions is proposed. The sensor was fabricated by coating the tip of the optical fiber by chitosan. The two chitosan surfaces serve as mirrors which form a Fabry-Perot interferometer. The characterization results indicate that the sensor has a linear response with sensitivity of 0.0884 dBm/ppm with a correlation factor of 0.9665...

We investigated a novel and ultracompact polymer-capped Fabry-Perot interferometer, which is based on a polymer capped on the endface of a single mode fiber (SMF). The proposed Fabry-Perot interferometer has advantages of easy fabrication, low cost, and high sensitivity. The variation of the Fabry-Perot cavity length can be easily controlled by using the motors of a normal arc fusion splicer. M...

An optical configuration employing two conventional Michelson interferometers and a fiber Fabry-Perot interferometer connected in parallel is used to demonstrate the principle of common mode rejection of both the amplitude and frequency noise of a semiconductor laser. Common mode noise rejection is maximized when the outputs of the two interferometers with matched path imbalance, fringe visibil...

Abstrucr-Two-diode laser-pumped Nd : YAG lasers have been frequency stabilized to a commercial 6.327 GHz free spectral range Fabry-Perot interferometer yielding a best-case beatnote linewidth of 330 mHz. In addition, a Fabry-Perot interferometer with a free spectral range of 680 MHz, a linewidth of 25 kHz, and a finesse of 27 500 has been built and when it was substituted in place of the commer...

The optical structure of general commercial interferometers, e.g., the Michelson interferometers, is based on a non-common optical path. Such interferometers suffer from environmental effects because of the different phase changes induced in different optical paths and consequently the measurement precision will be significantly influenced by tiny variations of the environmental conditions. Fab...

We propose a matched Fabry-Perot configuration for frequency stabilization where each user locks its laser to a local Fabry-Perot interferometer which is perfectly matched to a master Fabry-Perot. Experimentally, a user Fabry-Perot was matched and locked to a remote master Fabry-Perot.

An hourglass in-fiber air microcavity Fabry-Perot interferometer is proposed in this paper, and its second reflecting surface of in-fiber microcavity is designed to be a concave reflector with the best curvature radius in order to improve the spectral characteristics. Experimental results proved that the extinction ratio of Fabry-Perot interferometer with cavity length of 60 μm and concave refl...

We present an analysis comparing the thermal noise in Fabry-Perot and delay-line interferometers with half-infinite mirrors. With a center to center spot spacing of at least twice the Gaussian beam spot size a delay line produces significantly less phase noise than a comparable Fabry-Perot interferometer for the case of half infinite mirrors at frequencies where test mass thermal noise usually ...