Thermal-Hydraulics analysis of pressurized water reactor core by using single heated channel model

Core Loading Design for Bushehr Pressurized Water Reactor

The modified out-in fuel management strategy was applied to the core loading design for the first four cycles of the Bushehr (Iran-1) KWU designed Pressurized Water Reactor (PWR). The minimum peak-to-average power density was chosen as the objective function of the optimization process. Lattice homogenization and group constants generation were performed by using the LEOPARD computer code. For ...

Pressurized Water Reactor Modelling with Modelica

In order to optimize and validate the design and the operation of its nuclear power plants facilities, EDF (Electricité de France) uses a proprietary tool called LEDA to perform static and dynamic simulation at the system level. EDF wishes to replace LEDA by state-of-the-art off-the-shelf tools, mainly to reduce maintenance cost while keeping up with the latest trend in modeling and simulation ...

The effect of fuel thermal conductivity on the behavior of LWR cores during loss-of-coolant accidents

The effect of variation in thermal conductivity of light water reactor fuel elements on core response during loss-of-coolant accident scenarios is examined. Initially, a simplified numerical analysis is utilized to determine the time scales associated with dissipation of stored energy from the fuel into the coolant once the fission reaction is stopped. The analysis is then followed by full reac...

Feed Water Line Cracking in Pressurized Water Reactor Plants

Neural Network Controller for the Pressurized Water Reactor Power Control

Although there have been some severe nuclear accidents such as Three Mile Island (USA), Chernobyl (Ukraine) and Fukushima (Japan), nuclear fission energy is still a source of clean energy that can substitute fossil fuels in a centralized way and in a great amount with commercial availability and economic competitiveness. Since the pressurized water reactor (PWR) is the most widely used nuclear ...

Actinide Burning in a Standard Pressurized Water Reactor

This study investigates actinide burning in a standard lattice PWR. It assumes that after the first loading of depleted uranium, plutonium and minor actinides, only the fission products are removed and only depleted uranium and the plutonium/minor actinide mixture are added. The relative concentrations of plutonium and minor actinide feed are always maintained the same as PWR discharge fuel aft...