this paper proposes a flexible power electronic transformer (fpet) for the application in the micro-grids. the low frequency transformer is usually used at the point of common coupling (pcc) to connect the low voltage grid and utility network to each other. the conventional 50hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. in this pap...

Decentralized control strategies are popular candidates in microgrids control because of their reliability and performance. Conventionally, droop control (as a main decentralized strategy) is been utilized in order to prevent permanent droop of voltage and frequency after change in loads and also to share generated power between distributed generation units. In this paper, a new droop control s...

highly self-ordered alumina nanopore arrays were fabricated using hard anodization technique in different mixtures of oxalic/phosphoric acid. the phosphoric acid concentration was varied from 0.05 to 0.3 m while the oxalic acid concentration was changed between 0.3 and 0.4 m. the self ordered nanoporous arrays were obtained in anodization voltage changing from 130 to 200 v. the interpore distan...

This paper includes modeling and simulation of 180 MW units of pumped storage power plant with Variable speed machines. In this method, voltage source inverters are used instead of traditional cyclo-converters. This paper aims to control the voltage source inverters and maintain DC voltage at a constant value. AC/ DC/ AC converter is used in system configuration structure in order to control an...

Induction motor is the most popular load in the industry, it is very important to study about the effects of voltage quality on induction motor performance. One of the most important voltage quality problems in power system is voltage unbalance. This paper evaluates and compares two methods including finite element method (FEM) and equivalent electrical circuit simulation for investigation ...

In this paper, a new structure of step-up dc-dc converter by using coupled inductor and active-clamped circuit is proposed. The proposed converter generates high voltage gain in comparison with the conventional dc-dc converters. Duo to using active-clamped circuit in the proposed topology the voltage stress on main switch is reduced. In addition the zero voltage switching (ZVS) in ON-state of m...

In a photovoltaic system, sun light energy is converted to electricity. The generatedelectricity has a low DC voltage. In order to increase voltage generated by photovoltaic cells (PV),an additive DC-DC converter is required to raise the low voltage to a good level which provides theconditions for connection to DC-DC converters. Low wastes, low costs, and high efficiency are someother specifica...

This paper studies the effects of symmetrical voltage sags on the operational characteristics of a Permanent Magnet Synchronous Motor (PMSM) by Finite Element Method (FEM). Voltage sags may cause high torque pulsations which can damage the shaft or equipment connected to the motor. By recognizing the critical voltage sags, sags that produce hazardous torque variations could be prevented. Simula...