Nanofluids, in which nano-sized particles (typically less than 100 nm) are suspended in liquids, have emerged as a possible effective way of improving the heat transfer performance of common fluids. In this paper a numerical study is performed to analyze the wall shear stress and heat transfer coefficient of γAl2O3-water nanofluids under laminar forced convection through a circular pipe. It is ...

In this paper conjugated heat transfer in thermal entrance region through the sinusoidal wavy channel has been investigated. The fluid flow is assumed to be laminar, steady state, incompressible, and hydrodynamically fully developed. A constant heat flux is assumed to be applied on the outer edge of the channel wall. In this study the governing equations including continuity, momentum and energ...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

in this study, mixed convection heat transfer and local and global entropy generation in aventilated square cavity have been investigated numerically. the natural convection effect isachieved by a constant heat flux imposed at the bottom wall and cooled by injecting a coldfollow. in order to investigate the effect of port location, four different placementconfigurations of the inlet and outlet ...

The pressure drop and heat transfer characteristics of a single-phase micro-channel heat sink were investigated both experimentally and numerically. The heat sink was fabricated from oxygen-free copper and fitted with a polycarbonate plastic cover plate. The heat sink consisted of an array of rectangular micro-channels 231 lm wide and 713 lm deep. Deionized water was employed as the cooling liq...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

In this study, the three-dimensional magnetohydrodynamic (MHD) boundary layer of stagnation-point flow in a nanofluid was investigated. The Navier–Stokes equations were reduced to a set of nonlinear ordinary differential equations using a similarity transform. The similarity equations were solved for three types of nanoparticles: copper, alumina and titania with water as the base fluid, to inve...

In this paper the characteristics of unsteady three-dimensional incompressible flows with heat transfer are obtained along with artificial compressibility of Chorin. At first, compatibility equations and pseudo characteristics for three-dimensional flows are derived from five governing equations (continuity equation, Momentum equations in three directions, and energy equation) and then results ...

Extended surfaces are one of the most important approaches to increase the heat transfer rate. According to the Fourier law, the heat transfer increases by increasing the contact surface of body and fluid. In this study, the effect of heat transfer has been investigated on two sets of engineered porous fins, in which the balls with different materials are sintered together. The fluid flow throu...