In this research paper, the performance of an air-cored axial flux permanent magnet synchronous generator is evaluated for low speed, direct drive applications using 3D finite element modeling and experimental tests. The structure of the considered machine consists of double rotor and coreless stator, which results in the absence of core losses, reduction of stator weight and elimination of cog...

The design of headframe foundation is always a cumbersome and difficult process. Traditionally its design is focused on 2D construction drawings. Currently it need its 3D model and often proceed finite element analysis for its importance. Based on the analysis of its design and model process we find that the core work of 3D modeling for headframe foundation is its vertices calculation. Therefor...

Three dimensioned finite element analysis were conducted on concrete block paving. In order to verify the calculated results, an experimental case study was analyzed. Good agreement was observed between the measured and the calculated results. Based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...

The present work investigates the effect of the elliptical three-dimensional (3D) cracks on a pipe with thickness transition, considering internal pressure. Level sets were defined using the extended finite element method (XFEM), the stress intensity factors (SIFs) of 3D cracks were investigated and compared between straight pipes and pipes with thickness transition. The results show that the X...

Numerical simulation of shielding effectiveness (SE) of a perforated shielding enclosure is carried out, using the finite element method (FEM). Possibilities of model definitions and differences between 2D and 3D models are discussed. An important part of any simulation is verification of the model results—here the simulation result are verified in terms of convergence of the model in dependenc...

The finite element modeling and experimental validation of 3D turning of grade two commercially pure titanium are presented. The Third Wave AdvantEdge machining simulation software is applied for the finite element modeling. Machining experiments are conducted. The measured cutting forces and chip thickness are compared to finite element modeling results with good agreement. The effects of cutt...

tooth/implant supported fixed prostheses may present biomechanical design problems, as the implant is rigidly anchored within the alveolus, whereas the tooth is attached by the periodontal ligament to the bone allowing movement. many clinicians prefer tooth/implant supported fixed prosthesis designs with rigid connectors. however, there are some doubts about the effect of attachment placement i...