in this thesis protic and aprotic ammonium-based ionic liquids were synthesized and their surface tensions were measured in the range of 298-373k. the protics are alkyl ammonium-based ils with the carboxylate (formate, acetate, propionate) anion and aprotics are quaternary ammonium-based ils with bis(trifluoromethylsulfonyl)imide anion. capillary rise method was used for surface tension measure...

in the first part of this thesis we explored wetting and its dynamics for small droplets. first, we showed how a simple feature of water droplets on a surface, i.e. laplace pressure, can be exploited to build a micropump. we investigated capillary pumping in microchannels both experimentally and numerically. putting two droplets of different sizes at the in/outlet of a microchannel, will ge...

drought is transient phenomenon , slow , repetitive and integral part of the climate of each region. drought begins with a substantial reduction in precipitation over the long-term average rainfall and over time, reduced soil moisture and surface and ground water resources will continue to decrease. this phenomenon is the most important in bakhtegan basin because of its importance in strategic ...

flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...

the study of air infiltration into the buildings is important from several perspectives that may be noted to energy and design of hvac systems, indoor air quality and thermal comfort and design of smoke control systems. given the importance of this issue, an experimental and numerical study of air infiltration through conventional doors and windows has been explored in iran. to this end, at fir...

asymmetric polyethersulfone (pes) microfiltration flat sheet membranes were composed by the phase inversion method (pim) and were used as supports. composite membranes were fabricated by coating silicone rubber as selective layer. effect of different concentrations of pes and pdms and different solvent such as nmp, dmf and dms effects as pes solvents and support thickness and different coagulat...

run-out-table (rot) is located between last finishing stand and down coiler in a hot strip mill. as the hot steel strip passes from rot, water jets impact on it from top and bottom and strip temperature decreases approximately from 800-950 °c to 500-750°c. the temperature history that strip experience while passing through rot affects significantly the metallurgical and mechanical properties, s...

objective: the objective of this study was to investigate the invitro fluoride release of four new self-adhesive resin cements; set (sdi, australia), breeze (pentron, usa), embrace wetbond (pulpdent, usa), g-cem (gc, japan) and to assess the bonding performance of these self-adhesive resin cements for bonding of orthodontic brackets. materials and methods: for fluoride release experiment, six ...

asymmetric membranes are widely used in many industrial membrane separation processes. the major advantage of membrane filtration over the conventional process is its ability to remove a wider spectrum of particles without using any chemicals. hollow fiber configuration offer many advantages over flat-sheet or tubular membranes. the spinning process of hollow fiber may look simple, yet it is te...