In this paper, a model for MEMS capacitive microphone is presented for integrated circuits.  The microphone has a diaphragm thickness of 1 μm, 0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm. Using the analytical and simulation results, the important features of MEMS capacitive microphone such as pull-in voltage and sensitivity are obtained 3.8v and 6.916 mV/Pa, respectively while there is no...

In this paper, a novel single-chip MEMS capacitive microphone is presented. The novelties of this method relies on the moveable aluminum (Al) diaphragm positioned over the backplate electrode, where the diaphragm includes a plurality of holes to allow the air in the gap between the electrode and diaphragm to escape and thus reduce acoustical damping in the microphone. Spin-on-glass (SOG) was us...

Audio applications such as mobile communication and hearing aid devices demand a small size but high performance, stable and low cost microphone to reproduce a high quality sound. Capacitive microphone can be designed to fulfill such requirements with some trade-offs between sensitivity, operating frequency range, and noise level mainly due to the effect of device structure dimensions and visco...

We present a MEMS microphone that converts the mechanical motion of a diaphragm, generated by acoustic waves, to an electrical output voltage by capacitive fingers. The sensitivity of a microphone is one of the most important properties of its design. The sensitivity is proportional to the applied bias voltage. However, it is limited by the pull-in voltage, which causes the parallel plates to c...

In MEMS capacitive microphone design, it is very critical to get highest yielding rate and sensitivity as the two major factors dominate structure design of microphone. The centralpost MEMS microphone is introduced in this paper to differentiate from traditional fixed membrane boundary microphone since the construction is simple and only few masks are required in the process so that the yieldin...

A highly innovative miniature silicon comb to sense differential microphone diaphragm has been developed that is highly stable when subjected to various bias voltages [1]. The bio-inspired microphone diaphragm consists of a 1 mm by 2 mm stiffener-reinforced plate fabricated out of phosphorous-doped polysilicon that is supported on a central hinge [2,3,4]. Interdigitated comb fingers are formed ...

In this paper, we proposed a MEMS capacitive microphone with a dual-anchored membrane. The proposed dual anchor could minimize the deviation of operating characteristics of the membrane according to the fabrication process variation. The membrane is connected and fixed to the back plate insulating silicon nitride structures instead to the sacrificial bottom insulating oxide layer so that its ef...

This work describes the design and optimization of three prototypes of microelectromechanical systems (MEMS) capacitive accelerometer-based middle ear microphone. The microphone is intended for middle ear hearing aids as well as future fully implantable cochlear prosthesis. The analysis is done using COMSOL Multiphysics. The maximum applied acceleration was considered 1g. Human temporal bones a...