In this paper, earthquake-resistance behaviors of existing masonry structures are evaluated based on a certain masonry building. The existing masonry structure is evaluated in its defects of primary design and construction measurements, seismic bearing capacity and durability. Based on results of evaluation, the seismic reinforcement design is introduced for improving earthquake-resistance beha...

in this paper the traditional covering plaster of masonry buildings is supplied with polypropylene and steel fiber to enhance their seismic behavior. the plaster mix proportion is determined by some initial mortar tests. also, one story, single span masonry building specimen plastered with different mortars is tested on a shaking table 8 times under a seismic input and the performance of the sp...

Masonry infill walls are often used as non-structural elements. According to the past structural failure, ignorance of interaction between infill walls and enclosed frame may lead to the different seismic response for non-ductile building frames. The main contribution of this paper is to analytically investigate the behavior of reinforced concrete with masonry infill panels as participating str...

Citation: Furukawa A, Kiyono J, Parajuli RR, Parajuli HR and Toki K (2017) Evaluation of Damage to a Historic Masonry Building in Nepal through Comparison of Dynamic Characteristics before and after the 2015 Gorkha Earthquake. Front. Built Environ. 3:62. doi: 10.3389/fbuil.2017.00062 Evaluation of Damage to a Historic Masonry Building in Nepal through Comparison of Dynamic Characteristics befor...

in some climates, massive buildings made of stone, masonry, concrete, earth and … can be utilized as one of the simplest and most effective ways of reducing building heating and cooling loads. very often such savings could be achieved in the design stage of the building and with a relatively low-cost. such declines in building envelope heat losses combined with optimized material configuration ...

pullback test has no scrupulous theoretical establishment. it is based on the hypothesis that the response ofthe structure can be related to the response of an equivalent single degree-of-freedom (sdof) system. this implies thatthe response is controlled by a single mode. in fact, the steel frame of each safe room, which is introduced within theunreinforced masonry buildings for protecting the ...

Performance based design (PBD) is an iterative exercise in which a preliminary trial design of the building structure is selected and if the selected trial design of the building structure does not conform to the desired performance objective, the trial design is revised. In this context, development of a fundamental approach for performance based seismic design of masonry infilled frames with ...

Masonry infill has been widely used as building material due to its cost effectiveness and availability.  The failure of these masonry infill walls during the past earthquakes have underscored the importance of ensuring the safety of the infill walls when it is subjected to lateral loads. In-plane and out of plane failures have been observed in many reinforced concrete framed building with maso...