The friction between an elastomer and a hard surface typically has two contributors, i.e., the interfacial and deformation components. The friction of viscoelastic hydrogel materials has been extensively studied between planar gel and planar substrate surfaces from the viewpoint of an interfacial interaction. However, the geometry of the contact in practical applications is much more complex. T...

Temper rolling or skin pass rolling is one of cold rolling processes composed of a horizontal pass cold rolling mill stand. In this process, the thick strip is subjected to very light reduction (0.5–4%) in thickness in the presence of high friction amplitudes. One of the basic parameters of strip rolling processes is temper rolling force. A new rolling force model has been proposed for temper r...

The structural and elastic properties of strongly curved cylindrical interface are characterised by spontaneous curvature, spontaneous area per molecule and three elastic moduli corrcsponding respectively to area extension, bending and mixed deformation of

Thin-walled structures like crash boxes may be used as energy absorption members in automotive chassis. There have been many studies addressing the behaviors of energy absorption members on frontal crash. These researches have attempted to predict the energy absorption and maximum impact load in shell structures. The energy absorption and maximum impact load depend on many parameters including ...

Numerous geological observations evidence that inelastic deformation occurs during sills and laccoliths emplacement. However, most models of sill and laccolith emplacement neglect inelastic processes by assuming purely elastic deformation of the host rock. This assumption has never been tested so that the role of inelastic deformation on the growth dynamics of magma intrusions remains poorly un...

The viscoelastic properties of nine silicone-, polysulfide-, and polyether-based impression materials were determined using creep tests. During deformation the materials demonstrated linear viscoelastic behavior. The creep compliance curves, recovery, and percent set were calculated. Permanent deformation in these materials is a result of lack of recovery of elastic deformation as well as visco...

The design of extrusion dies depends on the experience of the designer. After the die has been manufactured, it is tested during an extrusion trial and machined several times until it works properly. The die is designed by a trial and error method which is an expensive process in terms of time and the amount of scrap. In order to decrease the time and the amount of scrap, research is going on t...

one of the most important parts of power transmission in automotives is c.v. joint, which consists of four components where exterior bowl is one of them. due to its complexity, and importance in automobile and existence of high stresses, forging process is the only cost effective method of production. hence, the best method of production of this part is forging process. the exterior part of c.v...

Elastic stable intramedullary nailing (ESIN) is a minimally invasive technique. According to this technique, two elastic nails are introduced through the metaphysis into the medullary canal, advanced through the fracture site and impacted into the opposite metaphysis. These nails are preformed in a C-shaped manner, which allows for their precise orientation and the creation of an elastic system...