multiphase flows are commonly encountered in oil and gas industries. the transport of multiphase flow causes the formation of slug, the increase of pressure drop and the possibility of phase changes therefore, a set of simulation runs was performed to predict flow regimes in a horizontal pipeline, and the results were compared with the baker chart. the effects of small downward inclinations of ...

investigating nozzle’s orifice flow is challenging both experimentally and theoretically. this paper focuses on simulating flow inside diesel injector nozzle via ansys fluent v15. validation is performed with experimental results from winkhofler et al (2001). several important parameters such as mass flow rate, velocity profiles and pressure profiles are used for this validation. results includ...

in this paper, a non-isothermal two-phase flow in the cathode gas diffusion layer (gdl) of pem fuel cell is modeled. the governing equations including energy, mass and momentum conservation equations are solved by numerical methods. also, the optimal values of the effective parameters such as the electrodes porosity, gas diffusion layer (gdl) thickness and inlet relative humidity are calculated...

flow regime in dam's bottom outlet is divided in pressurized flow and free surface flow by the gate located for discharge control. down stream tunnel involves high velocity multi component air –water flow studied by mathematical model. in this research work, we used finite volume mixture two phase flow model. because of high reynolds number, standard two equations k-e turbulence model was ...

Defocusing digital particle image velocimetry (DDPIV) is the natural extension of planar PIV techniques to the third spatial dimension. In this paper we give details of the defocusing optical concept by which scalar and vector information can be retrieved within large volumes. The optical model and computational procedures are presented with the specific purpose of mapping the number density, t...

in this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. in numerical study, single and two-phase models have been used. in single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. effects of volume fraction a...

In some case of laboratory and industrial applications, various kind of measurement instruments must be placed in a conduit, in which multiphase fluid flows. Vortex shedding for any immersed body in flow field is created with a frequency, which according to flow conditions such as flow rates, geometry of body, etc. may be constant or variable. Failure may happen, if this frequency is close to o...

turbulence structure on the gas side of a wavy stratified flow was experimentally investigated in a near horizontal 18.7 cm (h) 10 cm (w) 5.5m (l) rectangular duct.by applying the variable interval time averaging (vita) technique to the hot wire anemometer measurements frequency of occurrence of turbulent events were detected near the air-water interface. experimental results showed that freque...

simulation of turbulence boiling, generation of vapour and predication of its behaviour are still subject to debate in the two-phase flow area and they receive a high level of worldwide attention. in this study, a new arrangement of the three dimensional governing equations for turbulence two-phase flow with heat and mass transfer are derived by using ensemble averaging two-fluid model and util...