The motion planning procedure described in this paper has been developed in order to eliminate or reduce the residual vibrations of electromechanical positioning systems, without augmenting the motion time (usually imposed by production requirements), nor introducing overtime for vibration damping. The proposed technique is based on a suitable choice of the motion law assigned to the servomotor...

Design The feasibility study, focuses on building up knowledge of and experience with the technology of using the "d31-effect" of piezoelectric material to damp the internal vibrations of the system. The investigation starts by specifying the mathematical relations that describes the piezoelectric "d31-effect" and particularising these relations for the actuator and sensor situation. The two vi...

We present measurements of the acoustic vibrations of single gold nanorods deposited on a glass substrate immersed in air and water by ultrafast pump-probe spectroscopy. The nanorods display two vibration modes, the breathing mode and the extensional mode. The damping time of the two modes is influenced by the environment, and a reduction of the quality factor is observed when the particles are...

Facility location-allocation models are used in a widespread variety of applications to determine the number of required facility along with the relevant allocation process. In this paper, a new mathematical model for the capacitated multi-facility location-allocation problem with probabilistic customer's locations and fuzzy customer’s demands under the Hurwicz criterion is proposed. Thi...

in this paper, the unified power flow controller (upfc) is enhanced with a chaotic particle swarm optimization (cpso) damping controller in order to mitigate the low frequency oscillations (lfo) in a single machine infinite bus (smib) power system. the designed damping controller is an optimized lead-lag controller, which extracts the speed deviation of the generator rotor and generates the out...

The increasing use of advanced sensing technologies for strain measurements necessitates the development of strain-based identification methodologies. In this study, a three-step neural network strategy, called direct soft parametric identification (DSPI), is presented to identify the member stiffness and damping parameters of a truss structure directly from free vibration-induced strains. The ...

In this paper, a novel compensator based on Magnetically Controlled Reactor with Fixed Capacitor banks (FC-MCR) is introduced and then power system stability in presence of this compensator is studied using an intelligent control method. The problem of robust FC-MCR-based damping controller design is formulated as a multi-objective optimization problem. The multi-objective problem is concocted ...

Literature review The rapid and continuous growth in aerospace, automotive, and military applications requires special materials that have high performance characteristics to build structures that can achieve and exceed target properties. One of the important material characteristic needed for some of these applications is the ability to absorb vibrations, typically referred to as the damping c...

In this article, bending, buckling, and free vibration of viscoelastic sandwich plate with carbon nanotubes reinforced composite facesheets and an isotropic homogeneous core on viscoelastic foundation are presented using a new first order shear deformation theory. According to this theory, the number of unknown’s parameters and governing equations are reduced and also the using of shear correct...

Non-linear vibration of the CRT shadow mask with impact damping wires is analyzed in consideration of the mask tension distribution and the effect of wire impact damping. A reduced order FEM model of the shadow mask is obtained from dynamic condensation of the mass and stiffness matrices, and damping wire is modelled using the lumped parameter method to effectively describe its contact interact...